| Author |
|
BeachBum
Super User
Joined: April 11 2007
Location: United States
Online Status: Offline
Posts: 1880
|
| Posted: January 10 2009 at 11:43 | IP Logged
|
|
|
Glad to see it is now working. Just a few thoughts.. The X10 signal was being absorbed by something. Don’t know if you had the receiver on a different phase or there is a lot of noise in the circuit or a surge protector or computers on the same line caused your problem.
Lee your keyboard is faster than mine.... 
Edited by BeachBum - January 10 2009 at 11:44
__________________
Pete - X10 Oldie
|
| Back to Top |
|
| |
grif091
Super User
Joined: March 26 2008
Location: United States
Online Status: Offline
Posts: 1357
|
| Posted: January 10 2009 at 12:23 | IP Logged
|
|
|
Hi Pete, Glad you folks were able to offer the suggestions that got Williams system working. Nadler did a nice job of explaining the trigger process. Can be difficult to get a newbie going because there are some many possible areas that need attention. I was amazed that I actually beat your post. Normally it has been the other way around.
Anyway, nice job both of you getting the system working!
Edited by grif091 - January 11 2009 at 00:34
__________________
Lee G
|
| Back to Top |
|
| |
BeachBum
Super User
Joined: April 11 2007
Location: United States
Online Status: Offline
Posts: 1880
|
| Posted: January 10 2009 at 12:35 | IP Logged
|
|
|
Cleanup post...
Edited by BeachBum - January 10 2009 at 14:05
__________________
Pete - X10 Oldie
|
| Back to Top |
|
| |
grif091
Super User
Joined: March 26 2008
Location: United States
Online Status: Offline
Posts: 1357
|
| Posted: January 10 2009 at 13:14 | IP Logged
|
|
|
Cleanup post.
Edited by grif091 - January 11 2009 at 00:37
__________________
Lee G
|
| Back to Top |
|
| |
williammanda
Groupie
Joined: December 03 2008
Location: United States
Online Status: Offline
Posts: 84
|
| Posted: January 10 2009 at 13:17 | IP Logged
|
|
|
Well it seems I made a bad assumption. I thought that the access points would couple the x10 signals too. I tried the rr501 and the plm on each phase and it worked but when I put each on a different phase it didn't work. I have a phase coupler for x10 and I will install it later today.
Thanks
Edited by williammanda - January 10 2009 at 13:32
|
| Back to Top |
|
| |
grif091
Super User
Joined: March 26 2008
Location: United States
Online Status: Offline
Posts: 1357
|
| Posted: January 10 2009 at 13:29 | IP Logged
|
|
|
Unfortunately none of the Insteon devices repeat X10 signals on the powerline or on RF coupling. Even the older Insteon SignaLincs which preceded the Access Points did not couple X10 signals.
__________________
Lee G
|
| Back to Top |
|
| |
Active Topics 
Memberlist 
Search 
Help
Register 
Login
PowerHome Messageboard : PowerHome General
Topic: Sample setup
