Active TopicsActive Topics  Display List of Forum MembersMemberlist  Search The ForumSearch  HelpHelp
  RegisterRegister  LoginLogin
PowerHome Programming
 PowerHome Messageboard : PowerHome Programming
Subject Topic: Insteon Dim/Bright Levels Post ReplyPost New Topic
Author
Message << Prev Topic | Next Topic >>
dhoward
Admin Group
Admin Group
Avatar

Joined: June 29 2001
Location: United States
Online Status: Offline
Posts: 4447
Posted: December 08 2006 at 19:28 | IP Logged Quote dhoward
Chuck,

Took me a minute but I finally figured out what you were asking.

You can do it a couple of different ways. You can use the PowerHome "Palm Pad" under the "Control" menu. If you've setup the particular X10 address in the Devices section, then you can do it from the Device Status screen. You can also do it from the PowerHome Multi-Editor using the following formula:

ph_x10("YOUR CTRL ID","F",5,0) + ph_x10("YOUR CTRL ID","F",102,0)

HTH,

Dave.
Back to Top View dhoward's Profile Search for other posts by dhoward Visit dhoward's Homepage
 

If you wish to post a reply to this topic you must first login
If you are not already registered you must first register

<< Prev Page of 3
  Post ReplyPost New Topic
Printable version Printable version

Forum Jump
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot delete your posts in this forum
You cannot edit your posts in this forum
You cannot create polls in this forum
You cannot vote in polls in this forum