Active TopicsActive Topics  Display List of Forum MembersMemberlist  Search The ForumSearch  HelpHelp
  RegisterRegister  LoginLogin
PowerHome Programming
 PowerHome Messageboard : PowerHome Programming
Subject Topic: sc2800 Post ReplyPost New Topic
Author
Message << Prev Topic | Next Topic >>
bedwuff
Newbie
Newbie


Joined: January 14 2007
Online Status: Offline
Posts: 1
Posted: January 14 2007 at 08:07 | IP Logged Quote bedwuff
I have just added an sc2800 alarm to my system, and I want to know if it's possible to get power home to tell the alarm to trigger. This is because I already have ms13 motion detectors set up and I don't want to have to replace them with ms10 as, this could prove somewhat expensive.
Back to Top View bedwuff's Profile Search for other posts by bedwuff
 
TonyNo
Moderator Group
Moderator Group
Avatar

Joined: December 05 2001
Location: United States
Online Status: Offline
Posts: 2889
Posted: January 14 2007 at 09:33 | IP Logged Quote TonyNo
Welcome to PowerHome!

I did some digging and it looks possible. You could use a relay connected to the wired input zone and controlled by PH.

This could be done with an X10 Universal module or an appliance module that switches a wall wart to power a DC relay.
Back to Top View TonyNo's Profile Search for other posts by TonyNo Visit TonyNo's Homepage
 

If you wish to post a reply to this topic you must first login
If you are not already registered you must first register

  Post ReplyPost New Topic
Printable version Printable version

Forum Jump
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot delete your posts in this forum
You cannot edit your posts in this forum
You cannot create polls in this forum
You cannot vote in polls in this forum