| Author |
|
jhendrix
Newbie
Joined: March 13 2007
Location: United States
Online Status: Offline
Posts: 1
|
| Posted: March 20 2007 at 11:58 | IP Logged
|
|
|
I am able to program links into my keypadlinc, but I am not able to configure the buttons through the keypad tab.
When I double click on my keypad, I get the following "error reading data from keypadlinc".
My PLC is as close to the keypad as possible, both physically and electrically. I wired the basement and it is about 3 feet from the keypad, and the only other items on the circuit are 3 other insteon dimmers.
I was able to get to the keypad screen a few days ago, but not any more.
I'm still using the demo (under 30 days) version of powerhome, is there a limitation to what I can do with this version?
|
| Back to Top |
|
| |
tbeckman
Senior Member
Joined: December 30 2007
Location: United States
Online Status: Offline
Posts: 149
|
| Posted: December 30 2007 at 20:43 | IP Logged
|
|
|
I get this same error... anyone ever figure this out?
jhendrix wrote:
I am able to program links into my keypadlinc, but I am not able to configure the buttons through the keypad tab.
When I double click on my keypad, I get the following "error reading data from keypadlinc".
My PLC is as close to the keypad as possible, both physically and electrically. I wired the basement and it is about 3 feet from the keypad, and the only other items on the circuit are 3 other insteon dimmers.
I was able to get to the keypad screen a few days ago, but not any more.
I'm still using the demo (under 30 days) version of powerhome, is there a limitation to what I can do with this version? |
|
|
|
| Back to Top |
|
| |
|
|
Active Topics 
Memberlist 
Search 
Help
Register 
Login
PowerHome Messageboard : PowerHome General
Topic: Problem with keypadlinc
